DESCRIPTION: ELMER'S GLITTER (ALL COLORS)
PRODUCT TYPE: PLASTIC COATED ALUMINUM
APPLICATION: E480, E481, E482, E483, E484, E485.
MSDS Prepared by:
Elmer's Products, Inc. Emergency Phone Number
1000 Kingsmill Parkway Poison Control Center
Columbus, OH 43229 1-800-228-5635 ext 22
For additional health, safety or regulatory information, call 614-225-7695.
Call 1-800-848-9400 to place an order or request additional MSDSs.
No hazardous ingredients known to company.
Appearance Metallic flakes
Odor Slight plastic
CAUTION!
Will burn.
May cause irritation of nose, throat and lungs if allowed to become
airborne.
HEALTH = 1 (slight)
FLAMMABILITY = 1 (slight)
REACTIVITY = 0 (minimal)
INGESTION: No hazards known to company.
INHALATION: Not expected to be harmful under normal conditions of
use. However, if allowed to become airborne, may cause
irritation of nose, throat and lungs.
SKIN: No hazards known to company.
EYES: No hazards known to company.
None of the components present in this product at concentrations equal
to or greater than 0.1% have been listed by NTP, classified by IARC,
nor regulated by OSHA as a carcinogen.
INGESTION: If accidentally swallowed, dilute by drinking large
quantities of water. Immediately contact poison control
center or hospital emergency room for any other
additional treatment directions.
INHALATION: Remove to fresh air.
EYES: Immediately flush eyes with plenty of water. Call a
physician if irritation persists.
Autoignition Temperature Not available
Upper/Lower Flammable Limits Not available
Up/Lower Explosive Limits, % by Vol Not available
Flash Point > 96 deg C
Will burn.
In case of fire, use water spray, dry chemical, foam or CO2. Use
water to keep fire-exposed containers cool.
Sweep (scoop) up and remove to a chemical disposal area. Prevent
entry into natural bodies of water.
Handle in accordance with good industrial hygiene and safety
practices. Always use appropriate Personal Protective Equipment
(PPE).
INHALATION: Avoid prolonged or repeated breathing of dust or
vapor.
Keep container closed.
Keep away from heat, sparks, flame and other ignition sources.
Keep away from acids.
Keep away from alkali.
If airborne contaminants are generated when the material is heated or
handled, sufficient ventilation in volume and air flow patterns should
be provided to keep air contaminant concentration levels below
acceptable criteria.
Where air contaminants can exceed acceptable criteria, use NIOSH/MSHA
approved respiratory protection equipment. Respirators should be
selected based on the form and concentration of contaminants in air
in accordance with OSHA laws and regulations or other applicable
standards or guidelines, including ANSI standards regarding
respiratory protection.
None established
Percent Volatiles 0
pH @ 25 C Not available
Specific Gravity 2.60
Appearance Metallic flakes
Autoignition Temperature Not available
Boiling Point Not applicable
Vapor Density (Air=1) Not applicable
Vapor Pressure, mm Hg @ 20 C Not applicable
Evaporation Rate (Butyl Acetate=1) Not applicable
Upper/Lower Flammable Limits Not available
Up/Lower Explosive Limits, % by Vol Not available
Flash Point > 96 deg C
Freezing Point Not applicable
Odor Slight plastic
Odor Threshold, ppm Not available
Solubility in Water Negligible
Coefficient of Water/Oil Distrib. Not applicable
Normally stable as defined in NFPA 704-12(4-3.1).
Heat, flame, strong acids or alkaline materials.
Oxides of carbon.
Will not occur.
None known to company.
INGESTION: Not toxic orally when tested as described in 16 CFR Part
1500.3 (c)(1) and (2).
EYES: Not an irritant when tested as described in 16 CFR
Part 1500.42.
Not determined.
Dispose of according to local, state/provincial, and federal
requirements.
The data provided in this section is for information only and may not
be specific to your package size. You will need to apply the
appropriate regulations to properly classify your shipment for
transportation.
Non-Regulated.
Not determined.
This material is not a "health hazard" or a "physical hazard" as
determined when reviewed according to the requirements of the
Occupational Safety and Health Administration 29 CFR Part 1910.1200
"Hazard Communication" Standard.
Does not meet any hazard category
This product contains the following toxic chemical(s) subject to the
reporting requirements of Section 313 of Title III of the Superfund
Amendments and Reauthorization Act of 1986, and Subpart C-Supplier
Notification Requirement of 40 CFR Part 372.
Aluminum (Fume or Dust) 7429-90-5 2.00%
All reportable chemical substances are listed on the TSCA Inventory.
We rely on certifications of compliance from our suppliers for
chemical substances not manufactured by us.
This product has been classified in accordance with the hazard
criteria of the Controlled Products Regulation (CPR) and the MSDS
contains all the information required by the CPR.
Not a controlled product
All reportable chemical substances are listed on the Domestic
Substances List (DSL) or otherwise comply with CEPA new substance
notification requirements.
This product contains the following chemical(s) subject to the
reporting requirements of the Canadian Environmental Protection Act
(CEPA) subsection 16(1), National Pollutant Release Inventory.
Aluminum (fume or dust) 7429-90-5 2.00%
AP (Non-Toxic): Products bearing the AP (Non-Toxic) Product Seal of
The Art & Creative Materials Institute, Inc. (ACMI) are certified in a
program of toxicological evaluation by a medical expert to contain no
materials in sufficient quantities to be toxic or injurious to humans
or to cause acute or chronic health problems. This program is
reviewed by ACMI's Toxicological Advisory Board. These products are
certified by ACMI to be labeled in accordance with the chronic hazard
labeling standard, ASTM D-4236 and Federal Law, P.L. 100-695. In
addition, there is no physical hazard as defined within 29 CFR Part
1910.1200(c).
The OSHA Hazard Communication Standard 29CFR 1910.1200 and the Workplace
Hazardous Materials Information System (WHMIS) require that the information
contained on these sheets be made available to your workers. Educate and
train your workers regarding OSHA and WHMIS precautions. Instruct your
workers to handle this product properly. Consult with appropriate experts
to guard against hazards associated with use of this product and its
ingredients.
SELLER MAKES NO WARRANTY, EXPRESS OR IMPLIED, CONCERNING THE PRODUCT OR THE
MERCHANTABILITY OR FITNESS THEREOF FOR ANY PURPOSE, except that the product
shall conform to contracted specifications, and that the product does not
infringe any valid United States or Canadian patent. No claim of any kind
shall be greater in amount than the purchase price of the quantity of
product in respect of which damages are claimed. In no event shall Seller
be liable for incidental or consequential damages, whether Buyer's claim is
based on contract, breach of warranty, negligence or otherwise.
CUR ISSUE 10-NOV-99
PREVIOUS ISSUE: 17-DEC-96