DESCRIPTION: ELMER'S CRAFT BOND TACKY GLUE PRODUCT TYPE: PVAC BASED ADHESIVE APPLICATION: FOR PRODUCT CODES SEE SECTION 16
MSDS Prepared by: Elmer's Products, Inc. Emergency Phone Number 1000 Kingsmill Parkway Poison Control Center Columbus, OH 43229 1-800-228-5635 ext 22 For additional health, safety or regulatory information, call 614-225-7689. Call 1-800-848-9400 to place an order or request additional MSDSs.
No hazardous ingredients known to Borden.
Appearance Milky white gel Odor Mild acetic aroma Not a significant fire hazard.
HEALTH = 1 (slight) FLAMMABILITY = 0 (minimal) REACTIVITY = 0 (minimal)
INGESTION: Not expected to be harmful under normal conditions of use. INHALATION: Not expected to be harmful under normal conditions of use. However, if allowed to become airborne, may cause irritation of nose, throat and lungs. SKIN: May cause irritation on prolonged or repeated contact. EYES: May cause irritation on prolonged or repeated contact.
None of the components present in this product at concentrations equal to or greater than 0.1% have been listed by NTP, classified by IARC, nor regulated by OSHA as a carcinogen.
INGESTION: If accidently swallowed, dilute by drinking large quantities of water. Immediately contact poison control center or hospital emergency room for any other additional treatment directions. INHALATION: Remove to fresh air. SKIN: In case of irritation, flush with water. EYES: Immediately flush eyes with plenty of water. Call a physician if irritation persists.
Autoignition Temperature Not available Upper/Lower Flammable Limits Not applicable Up/Lower Explosive Limits, % by Vol Not applicable Flash Point Not applicable Will not burn unless water has evaporated. Dried material may burn. In case of fire, water should be used to keep fire-exposed containers cool.
Soak up with absorbent material and remove to a chemical disposal area. Prevent entry into natural bodies of water.
Handle in accordance with good industrial hygiene and safety practices. INHALATION: Avoid prolonged or repeated breathing of vapor. SKIN: Avoid prolonged or repeated contact with skin and clothing. EYES: Avoid prolonged or repeated contact with eyes.
Keep from freezing. Store in a cool, dry place. Keep containers tightly closed.
If airborne contaminants are generated when the material is heated or handled, sufficient ventilation in volume and air flow patterns should be provided to keep air contaminant concentration levels below acceptable criteria.
Where air contaminants can exceed acceptable criteria, use NIOSH/MSHA approved respiratory protection equipment. Respirators should be selected based on the form and concentration of contaminants in air in accordance with OSHA laws and regulations or other applicable standards or guidelines, including ANSI standards regarding respiratory protection. Use goggles if contact is likely. Wear impervious gloves as required to prevent skin contact.
Percent Volatiles 48 pH @ 25 C 5.1 Specific Gravity 1.07 Appearance Milky white gel Autoignition Temperature Not available Boiling Point 100 deg C Vapor Density (Air=1) < 1 Vapor Pressure, mm Hg @ 20 C 17.5 Evaporation Rate (Butyl Acetate=1) < 1 Upper/Lower Flammable Limits Not applicable Up/Lower Explosive Limits, % by Vol Not applicable Flash Point Not applicable Freezing Point 0 deg C Odor Mild acetic aroma Odor Threshold, ppm Not available Solubility in Water Dispersible Coefficient of Water/Oil Distrib. Not available
Normally stable as defined in NFPA 704-12(4-3.1).
Strong acids and alkaline materials.
Will not occur.
None known to Borden.
See Section 3 Hazards Identification information.
Recover free liquid. Absorb residue and dispose of according to local, state/provincial, and federal requirements.
The data provided in this section is for information only and may not be specific to your package size. You will need to apply the appropriate regulations to properly classify your shipment for transportation. Non-Regulated.
This material is not a "health hazard" or a "physical hazard" as determined when reviewed according to the requirements of the Occupational Safety and Health Administration 29 CFR Part 1910.1200 "Hazard Communication" Standard.
Does not meet any hazard category
This product contains the following toxic chemical(s) subject to the reporting requirements of Section 313 of Title III of the Superfund Amendments and Reauthorization Act of 1986, and Subpart C-Supplier Notification Requirement of 40 CFR Part 372. None required per SARA TITLE III SECTION 313.
All reportable chemical substances are listed on the TSCA Inventory. We rely on certifications of compliance from our suppliers for chemical substances not manufactured by Borden.
This product has been classified in accordance with the hazard criteria of the Controlled Products Regulation (CPR) and the MSDS contains all the information required by the CPR. Not a controlled product
All reportable chemical substances are listed on the Domestic Substances List (DSL) or otherwise comply with CEPA new substance notification requirements.
This product contains the following chemical(s) subject to the reporting requirements of the Canadian Environmental Protection Act (CEPA) subsection 16(1), National Pollutant Release Inventory. None required.
AP (Non-Toxic): Products bearing the AP (Non-Toxic) Product Seal of The Art & Creative Materials Institute, Inc. (ACMI) are certified in a program of toxicological evaluation by a medical expert to contain no materials in sufficient quantities to be toxic or injurious to humans or to cause acute or chronic health problems. This program is reviewed by ACMI's Toxicological Advisory Board. These products are certified by ACMI to be labeled in accordance with the chronic hazard labeling standard, ASTM D-4236 and Federal Law, P.L. 100-695. In addition, there is no physical hazard as defined within 29 CFR Part 1910.1200(c). MSDS covers items: U.S.: E430 Canada: 62430
The OSHA Hazard Communication Standard 29CFR 1910.1200 and the Workplace Hazardous Materials Information System (WHMIS) require that the information contained on these sheets be made available to your workers. Educate and train your workers regarding OSHA and WHMIS precautions. Instruct your workers to handle this product properly. Consult with appropriate experts to guard against hazards associated with use of this product and its ingredients.
SELLER MAKES NO WARRANTY, EXPRESS OR IMPLIED, CONCERNING THE PRODUCT OR THE MERCHANTABILITY OR FITNESS THEREOF FOR ANY PURPOSE, except that the product shall conform to contracted specifications, and that the product does not infringe any valid United States or Canadian patent. No claim of any kind shall be greater in amount than the purchase price of the quantity of product in respect of which damages are claimed. In no event shall Seller be liable for incidental or consequential damages, whether Buyer's claim is based on contract, breach of warranty, negligence or otherwise.
CUR ISSUE 17-DEC-96 PREVIOUS ISSUE: 20-FEB-96