Material Safety Data
Sheet
1.
Chemical Product and Company Identification
DESCRIPTION: ELMER'S NO-WRINKLE GLUE PEN
PRODUCT TYPE: STARCH-BASED ADHESIVE
APPLICATION: FOR PRODUCT CODES SEE SECTION 16
·
Manufacturer/Supplier
Information
MSDS Prepared by:
Elmer's Products, Inc. Emergency Phone Number
1 Easton Oval Poison Control Center
Columbus, OH 43219 1-888-516-2502
For additional health, safety or regulatory information, call 1-888-435-6377.
Call 1-800-848-9400 to place an order or request additional MSDSs.
2.
Composition, Information on Ingredients
No hazardous ingredients known to company.
3.
Hazards Identification
3.1
Emergency Overview
Appearance Yellow-orange liquid
Odor Odorless
CAUTION!
Not a significant fire hazard.
·
HMIS
Rating
HEALTH = 1 (slight)
FLAMMABILITY = 0 (minimal)
REACTIVITY = 0 (minimal)
3.2
Potential Health Effects
·
Immediate
Hazards
INGESTION: No hazards known to company.
INHALATION: Not expected to be harmful under normal conditions of
use. However, if allowed to become airborne, may cause
irritation of nose, throat and lungs.
SKIN: No hazards known to company.
EYES: No hazards known to company.
·
Delayed
Hazards
None of the components present in this product at concentrations equal
to or greater than 0.1% have been listed by NTP, classified by IARC,
nor regulated by OSHA as a carcinogen.
4.
First Aid Measures
INGESTION: If accidentally swallowed, dilute by drinking large
quantities of water. Immediately contact poison control
center or hospital emergency room for any other
additional treatment directions.
INHALATION: Remove to fresh air.
EYES: Immediately flush eyes with plenty of water. Call a
physician if irritation persists.
5.
Fire Fighting Measures
Autoignition Temperature Not applicable
Upper/Lower Flammable Limits Not applicable
Flash Point Not applicable
Will not burn unless water has evaporated. Dried material may
burn.
In case of fire, use water spray, dry chemical, foam or CO2. Use
water to keep fire-exposed containers cool.
6.
Accidental Release Measures
Soak up with absorbent material and remove to a chemical disposal
area. Prevent entry into natural bodies of water.
7.
Handling and Storage
7.1
Handling
Handle in accordance with good industrial hygiene and safety
practices. Always use appropriate Personal Protective Equipment
(PPE).
INHALATION: Avoid prolonged or repeated breathing of vapor.
7.2
Storage
Store at room temperature.
Keep from freezing.
Keep containers tightly closed.
8.
Exposure Controls/Personal Protection
8.1
Exposure Controls
If airborne contaminants are generated when the material is heated or
handled, sufficient ventilation in volume and air flow patterns should
be provided to keep air contaminant concentration levels below
acceptable criteria.
8.2
Personal Protection
Where air contaminants can exceed acceptable criteria, use NIOSH/MSHA
approved respiratory protection equipment. Respirators should be
selected based on the form and concentration of contaminants in air
in accordance with OSHA laws and regulations or other applicable
standards or guidelines, including ANSI standards regarding
respiratory protection.
8.3
Exposure Guidelines
None established
9.
Physical and Chemical Properties
Percent Volatiles 28
pH @ 25 C 2.6
Specific Gravity 1.2
Appearance Yellow-orange liquid
Autoignition Temperature Not applicable
Boiling Point 100 deg C
Vapor Density (Air=1) < 1
Vapor Pressure, mm Hg @ 20 C 17.5
Evaporation Rate (Butyl Acetate=1) < 1
Upper/Lower Flammable Limits Not applicable
Flash Point Not applicable
Freezing Point 0 deg C
Melting point Not applicable
Odor Odorless
Odor Threshold, ppm Not available
Solubility in Water Soluble
10.
Stability and Reactivity
Normally stable as defined in NFPA 704-12(4-3.1).
·
Incompatibilities:
None known to company.
·
Decomposition
products may include:
Oxides of carbon.
·
Hazardous
polymerization:
Will not occur.
·
Other
Hazards:
None known to company.
11.
Toxicological Information
See Section 3 Hazards Identification information.
12.
Ecological Information
Not determined.
13.
Disposal Considerations
Recover free liquid. Absorb residue and dispose of according to
local, state/provincial, and federal requirements.
14.
Transport Information
14.1
U.S. Department of Transportation (DOT)
The data provided in this section is for information only and may not
be specific to your package size. You will need to apply the
appropriate regulations to properly classify your shipment for
transportation.
Non-Regulated.
14.2
Canadian Transportation of Dangerous Goods (TDG)
Non-Regulated.
15.
Regulatory Information (Selected Regulations)
15.1
U.S. Federal Regulations
·
OSHA
Hazard Communication Standard 29CFR1910.1200
This material is not a "health hazard" or a "physical hazard" as
determined when reviewed according to the requirements of the
Occupational Safety and Health Administration 29 CFR Part 1910.1200
"Hazard Communication" Standard.
·
SARA
Title III: Section 311/312
Does not meet any hazard category
·
SARA
Title III Section 313 and 40 CFR Part 372
This product contains the following toxic chemical(s) subject to the
reporting requirements of Section 313 of Title III of the Superfund
Amendments and Reauthorization Act of 1986, and Subpart C-Supplier
Notification Requirement of 40 CFR Part 372.
None required per SARA TITLE III SECTION 313.
·
TSCA
Section 8(b) Inventory
All reportable chemical substances are listed on the TSCA Inventory.
We rely on certifications of compliance from our suppliers for
chemical substances not manufactured by us.
15.2
Canadian Regulations
·
Workplace
Hazardous Materials Information System (WHMIS)
This product has been classified in accordance with the hazard
criteria of the Controlled Products Regulation (CPR) and the MSDS
contains all the information required by the CPR.
Not a controlled product
·
Canadian
Environmental Protection Act (CEPA)
All reportable chemical substances are listed on the Domestic
Substances List (DSL) or otherwise comply with CEPA new substance
notification requirements.
·
National
Pollutant Release Inventory (NPRI)
This product contains the following chemical(s) subject to the
reporting requirements of the Canadian Environmental Protection Act
(CEPA) subsection 16(1), National Pollutant Release Inventory.
None required.
16.
Other Information
AP (Non-Toxic): Products bearing the AP (Non-Toxic) Product Seal of
The Art & Creative Materials Institute, Inc. (ACMI) are certified in a
program of toxicological evaluation by a medical expert to contain no
materials in sufficient quantities to be toxic or injurious to humans
or to cause acute or chronic health problems. This program is
reviewed by ACMI's Toxicological Advisory Board. These products are
certified by ACMI to be labeled in accordance with the chronic hazard
labeling standard, ASTM D-4236 and Federal Law, P.L. 100-695. In
addition, there is no physical hazard as defined within 29 CFR Part
1910.1200(c).
MSDS covers items:
U.S.: E132
Canada: 60132
·
User's
Responsibility
The OSHA Hazard Communication Standard 29CFR 1910.1200 and the Workplace
Hazardous Materials Information System (WHMIS) require that the information
contained on these sheets be made available to your workers. Educate and
train your workers regarding OSHA and WHMIS precautions. Instruct your
workers to handle this product properly. Consult with appropriate experts
to guard against hazards associated with use of this product and its
ingredients.
·
Disclaimer
SELLER MAKES NO WARRANTY, EXPRESS OR IMPLIED, CONCERNING THE PRODUCT OR THE
MERCHANTABILITY OR FITNESS THEREOF FOR ANY PURPOSE, except that the product
shall conform to contracted specifications, and that the product does not
infringe any valid United States or Canadian patent. No claim of any kind
shall be greater in amount than the purchase price of the quantity of
product in respect of which damages are claimed. In no event shall Seller
be liable for incidental or consequential damages, whether Buyer's claim is
based on contract, breach of warranty, negligence or otherwise.
CURRENT ISSUE: 14-NOV-07
PREVIOUS ISSUE: 14-JAN-04